If your PC frequently shows the intricate alamatan lawyer, or display an
error message, emit a continuous beep is regular or irregular, the PC
is most likely being in trouble, I will provide tips and solutions to
solve these problems and Your PC can function again as usual.
Problems or damage arising typically categorized in two types of damage are: Problem or damage Hardware and Software
For the Troubleshooting Guide Please Get The Tips & Tricks Of Us.
Damage Type Can be categorized into 2 categories, namely:
1. Damage Hardware (Hardware)
2. Damage On Software (Software)
Damage Hardware
The problem with the hardware components need serious treatment for
localized and difficult to be removed without the proper tools,
expertise and support experience. Explanation will revolve around the problems that often occur along with remedies.
1. Damage to the Power Supply
Symptoms: When turned on the PC does not react to anything, there is no
display on the monitor, there is no indicator light (LED) is lit, the
power supply fan is not spinning, the indicator light does not turn on
the monitor.
Solution: Check whether the cable is properly connected and installed
properly plug into the socket, check whether there is the on / off
behind exactly behind the Power Supply is in the On position, If you are
sure installed correctly but still no response to assure you please
replace power cord with you believe good. The problem occurs in the absence of incoming voltage, there is damage to the power cable.
Problem: When turned on the PC does not react to anything, there is no
display on the monitor, there is no indicator light (LED) is lit, the
power supply fan is not spinning, the indicator light on the monitor.
Solution: do as steps above, but if there is still no response means a
problem in Power Supply, PS Please change it, I suggest you should just
replace the faulty power supply with a new one, and be careful in the
installation.
Note: If the damage is only on Power Supply alone, When you replace it, the computer will return to work as normal. Unless there is a problem in other components such as the Mother Board, VGA Card and Memory.
2. Damage to the Mother Board
Symptoms: When turned on, there is no display on the monitor, the
indicator light (LED) on the front panel is lit, the indicator light
(LED) flashing monitors, power supply fan and the processor fan spins,
no beep sound on the speakers.
Solution: The first step off all power cables connected to the
electrical, data cable to the monitor, cable keyboad / mouse, and all
cables are connected to the CPU, and then remove all the screws cover
cashing. In an open case please also remove other
components, the voltage of the power supply cord is connected to the
motherboard, hard drive, floppy, careful not to rush the process. So is the card attached to the Mboard (VGA, Sound Card or other). Now attached to the motherboard just cashing it. Please check carefully Motherboadnya, see Chip (IC), Elko, transistor and others if there is a fire.
If there are no signs of burnt components Motherboard chances are still
good, but there are times when Mother board does not work because of
damage to the programs contained in the BIOS
Symptoms: The CPU time started and then did post after that process was
discontinued and was silent for a moment not directly go to the
operating system, and then the screen is the message "disk error, disk
Failur, after it appeared the message" press F1 to continou " after you
press the F1 key does not enter operating system and the message
"Operating system not found".
3. Damage Harddisk
Solution: Check the tension cables and data cables into the hard drive
is loose, should be tightened, then turn it on and let you listen to
what came out of the disk normal, if not normal means damaged hard drive
controller.
Symptoms: The CPU time started and then did post after it appeared the message "Operating system not found".
Solution: There is a possible operating system is damaged, can be
overcome by installing ualng or if you are using Windows 2000/XP OS
there Repairnya facilities. or possibly a hard drive is not detected and retune
Symptoms: hard disk bad sector?
Solution: There are several factors that cause bad sectors such occurs,
the voltage is unstable, there is often a sudden power loss, after
pemakaina not shot down, consumption is too long, there are two types of
bad sectors are physical and software ..... To overcome this there are
several ways, including using software to eliminate further BadSector
.... of change in eBook is in computer repair methods and what you get
if you join the Active Member.
4. Damage CD / DVD / ROM / RW & Floppy Disk
Symptoms: This type of damage is commonly encountered:
1. Not detected in windows
2. Not get out in CD
3. Can not read / write / can only read it. (CD)
4. Can not read / write / write protect (Floppy disk)
Solution:
1. Check the data cable and voltage cable into the CD-floppy, check in bios setup if it is detected? should be set to auto. Check whether the light is on, if not damage the controller.
2. Mechanical damage on the rubber motor or motors.
3. Usually the optical damage, but there may still be improved in a way to set the optical ualng.
4. Dirty Head, can be cleaned using Cutenbud
(The above steps are complete can be found in the e-book "method of
computer repair fast and accurate" and what you get if you join a member
perbaikankomputer.com
BIOS Problems
Symptoms: Be careful in Bios Update, as he got the wrong update your
BIOS version, not the PC so you can not even get into the BIOS.
Solution: Usually Update can not be undone, only certain types of
motherboards have a backup BIOS chip it, there is saved the original
BIOS types that can not be removed, to restore your stay special move
Jumper position that usually have no clue on the manuals . Then
hidupka PC and wait 10 seconds, the original BIOS on Restore, restore
Jumper position on the starting position, and the PC is ready to run
again. If the motherboard does not have pasilitas, the BIOS
chip should be sent to the manufacturer, type of BIOS you can see in
the manuals. Be careful not to install the BIOS IC legs broken or inverted position.
Symptoms: CPU Beep sound several times in the speaker and no display on the screen, when the monitor is not problematic.
Solution: Beep Beep indicates a specific error message from the BIOS, it
shows what kind of errors sound of what happens on the PC, usually an
error on non-detectable Memory, VGA card, which is not installed
properly, even Processor Monitor data cable could be the cause. Please
check the problem.
Following BIOS error message
Beep error Motherboard BIOS usually not all indicate the same error depends on the type of its BIOS.
[AMI BIOS]
Beep 1x: RAM / Memory not installed or Damaged Good, Beep 6x: Error Gate
A20 - Indicates damaged or IC Keyboard Gate A20 of his own, Beep 8x:
Grapihic Card / VGA Card is not installed properly or damaged, Beep 11x:
Checksum Error, check Batre Bios, and replace it with a new one.
[AWARD BIOS]
Beep 1x Length: RAM / Memory not installed or Damaged Good, Beep 1x 2x
Short Length: Damage On Graphic Card (VGA), Inspect Installation may
also not fit into the slot (less entry), Beep 1x 3x Long Short: Keyboard
failure or not installed. Beep is interrupted / continuous sound: RAM or Graphics Card not detected.
Batrey CMOS Damage / Weak
Symptoms: Appear message CMOS Checksum Vailure / Batrey Low, due
tegangna which to supply IC CMOS / BIOS is not normal because batrey
weak, so the BIOS settings back to factory default Default-nya/setingan
and hardware configurations must be set back.
Solution: Replace Soon his Batrey
Symptoms: The CPU is often Hang?
Solution: There are several factors going on hanging them: There
BadSector in Hard Drive, Ada Virus, There is a problem in the hardware
such as Memory Dirty / Damaged, Mboard Dirty / Damaged, Cooling Fan fan
rotation is already weak, unstable power supply should ..... not be
forced to use because it will result in more fatal, please contact: our
ability to resolve the issue
Symptoms often appear blue computer screen what causes it?
Solution: The message could be caused Blue Screen windows system is
broken, Can of Memory, Can the hard drive, can be from other components,
depending on the blue screen messages displayed.
Symptoms: The computer is so much slower than before, but not so slow initially
Solution: The cause of your computer slow process there are several
factors: Space hard drive is too full, too many programs / software that
takes hard disk space and memory, there is a virus, hard drive
BadSector.